It is possible to perform two pressing processes, such as laminating and slitting, simultaneously using a single machine. During two-process press operation, image processing is performed using a CCD camera in order to achieve improved positioning accuracy. Product Example 01 Rim Sheets for Backlights These are affixed to the tops of backlight units in order to join the LCD to the backlight. Die-punched double-sided tape with light blocking or reflective properties is used for this purpose. All burrs and foreign matter is eliminated, enhance the dimensional accuracy degree within ±0.1mm. Product Example 02 Reflective Panels for Backlights These are affixed to the bottoms of backlight units in order to reflect light from the back of the light guide plate to the entire screen. Tape can be affixed to specific portions of the panels, and alignment on a carrier, etc., is also possible. Product Example 03 Diffusing Plates for Backlights These are affixed to the tops of backlight units in order to diffuse light over a wide range and achieve even brightness for the entire unit. Tape can be affixed to specific portions of the plates, and alignment on a carrier, etc., is also possible. Product Example 04 Polarizing Plates for LCD Panels These are affixed to LCD panels to polarize the light. The sharpness of the cut surfaces is one of the key advantages of the processing. Product Example 05 Tab Tape This tab tape is designed to make protective film easier to remove.